Standard Cupboard Door Sizes Australia

This cabinet will have two doors at right angle to each other that will either open attached together as a bi fold door or open one door in front of the other.

Standard cupboard door sizes australia.

Increasing the base units also means an increase in full height cabinetry depth e g pantry and overheads. Standard dimensions for stock or diy base floor cabinets are 720mm high by 560mm deep without the door. Between 850mm and 1000mm. These are as follows.

The standard floor cabinet depth is 580mm inclusive of door thickness. 910 x 910mm wide the height and depth of these corner cabinets will remain the same as standard base cabinets. Floor cabinet widths generally increase by 100 or 150mm increments see fig. The standard height of doors is 2040 mm.

The height of kitchen cabinets to the top of the bench should be. The width of floor cabinets usually increase in multiples of 150mm i e. In australia the standard door size is 2040 x 820 mm x 35 mm. 300mm 450mm 600mm 750mm 900mm 1050mm 1200mm.

In australia the most common internal standard door for both panel and flush has a height of 2040mm a width of 820mm with a thickness of 35mm. Where before you would be forced to store these items in the deeper. While this is the most common standard door size there are other sizes which are popular and also deemed standard size and these are. 2040mm x 620mm x 35mm 2040mm x 720mm x 35mm.

However the doors are made slightly smaller so that they fit. The maximum door width for a base cabinet is 600mm. The standard size is. This helps drive down the cost of a door as having custom doors made is generally more expensive.

If you measure the space occupied by the door on one of your kitchen cabinets the chances are it ll measure something around 720mm in height by 500mm in width. With our overhead cabinets set to 400mm deep as opposed to the industry standard of 280 340mm this means you can now fit larger plates platters and items that don t get used very often in your overhead cabinets. Most kitchens are made in standard sizes. Standard door sizes allow for the mass production of doors ready made for installation.

The height of kickboards beneath the bottom of the cabinets should ideally be between 100mm and 200mm. A lot of new homes are built with higher ceilings and some of the doors are higher than the standard 2340 mm. This is probably the most typical kitchen cupboard door size.