Step By Step Roofing Installation

The first step to installing a metal roof is to take an accurate measurement of your roof s height length and width.

Step by step roofing installation.

Nail it down with your roofing gun top and bottom. Step by step roll roofing installation. During a diy roof installation job paying attention to manufacturer s directions is of the utmost importance. Install the roofing screws vertically along each rib in the panel.

Ice and water shield sticks to the wood decking which prevents any water leaks. This involves another four steps. You first measure the roof s width and length then add the desired overhang measuring from the lowest. Secure the screws but do not overtighten.

The above roof installation steps are intended to give you a basic guideline to install new roofing materials. Add an insulation layer so that it traps moisture between the sheathing and the metal roof. Install shingles from the lower left corner working to the right and also working up the roof slope. Ice and water shield installation next step is installing ice and water shield which is a special type of roofing underlayment.

Install the starter strip which is just a backing for the first visible row of shingles. Install a drip edge around the perimeter of the roof. Installing the roof. Prepare a valley between joined roofs by cutting a strip that is 18 inches wide and covers the entire length of.

The type of materials used will greatly affect the method of roof installation. Trim the shingles with your utility knife photo 14. You will need to order enough metal material to cover the entire roof and this process starts with measuring the full size of your roof in square feet. It must be installed at the bottom of the roof and at all roof penetrations chimneys pipe flanges roof connections etc.

This aluminum flashing protects the edges of the roof sheathing from water. The following 8 instruction steps will guide you through the installation of a metal roof. Install the shingles up and halfway past the vent hole or stack. Use the 1 25 inch nails to secure the metal strips on the flashing.

It stops water from getting through to the roof at. Getting the right result will help you determine the right amount of metal roofing material you ll need to order. Start by installing the edges. Seal the top nail holes and continue on up with your shingles.

The washer under the screw head should seal to the surface of the panel without bulging or shifting. Next install your vent or stack flashing over that row of shingles photo 13. Arrange the shingles so the ends and the.